Started by Bullet, July 15, 2013, 04:43:54 PM
Quote from: greenmeeny on August 01, 2013, 03:30:54 PMStops the rear brake going round and round when used.
Quote from: Nib on August 01, 2013, 10:48:02 PMAny more pics of your zxr Rob? Looks beautiful.
Quote from: Gilby104 on August 02, 2013, 10:02:25 AMQuote from: greenmeeny on August 01, 2013, 03:30:54 PMStops the rear brake going round and round when used. Is that true?
Quote from: Bullet on August 02, 2013, 03:13:45 PMyes, he's not winding you up its called a torsion arm, its what they used before they thought of putting a slot in the back of the swingarm to hold the caliper hanger in place on newer bikes.....
Quote from: Nat on August 02, 2013, 04:14:01 PMI thought they just put it there to make putting the wheel back in a pain in the ar3e!
Quote from: Bullet on October 09, 2013, 10:03:22 AM does anyone know of an easy way to get the existing head bearings off the lower yoke besides take them to a garage, because Im not paying £200 for a headstock bearing puller!
Quote from: Bullet on October 31, 2013, 10:34:06 AMspot the homemade tools, theres 2 of them in this photo.
Quote from: Bullet on October 31, 2013, 01:20:35 PM50% right spray bottle top is indeed an oil level tool! I did the head bearings using a metalworking vice and a hammer.
Quote from: Bullet on October 31, 2013, 01:20:35 PMThe other home made tool was 3 layers of cardboard tube sliced down the side so I can clip them around the fork leg and use them as a seal driver
Quote from: clipper on November 01, 2013, 12:39:21 PMWhat do I win?
Page created in 0.072 seconds with 17 queries.