whining noise while riding

Started by ben68, November 12, 2014, 06:56:52 PM

Previous topic - Next topic

ben68

still using my bike for work while the weather is still decent'ish and iv'e noticed what i can only describe as a whining sort of noise when i am accelerating it has never done this before... it only does it under load i tried pulling the clutch in and revving it while freewheeling and it stopped but as soon as i let the clutch out and accelerated it started again iv'e had the bike on the paddock stand to spun the backwheel to see if anything might be catching but nothing... apart from this the bike runs fine this has only come about over the last week or so any ideas would be appreciated the bike is an 05 r6 thanks in advance.

0luke0

Have you spun the front wheel?  Could be an airbox leak?

Could be a lot of things..

ben68

#2
I haven't spun the front wheel idon't think it's coming from there it only seems to do it under acceleration the bike seems to run fine apart from this noise it's definately not something i have just noticed either  :undecided:

Green_Ninja

Any changes, additions to the bike recently??

ash


ben68

no none at all.... i think it does it when you shut the throttle as well (clutch out) going to listen for it on the way to work in the morning to make sure i have  been that busy listening to it doing it while accelerating  :undecided: tbh it's hard to describe

ben68


m6rk


Chojin

Is the wife riding pillion?

I get the same symptom you describe a lot.

ben68

Quote from: Chojin on November 12, 2014, 09:24:10 PM
Is the wife riding pillion?

I get the same symptom you describe a lot.
:rofl:no couldn't get her anywhere near it so can't blame her for it  ;)

andy dutton

Camchain? Camchain Tensioner?

i have 04 R6 and tensioner gone on mine!

big gav

Its common for output shaft bearings to whine.

Get it hooned.

MOzZereLLa

The whining noise I usually hear is as I'm walking out the door to go for a ride....
Significantly faster than you.....

ben68

Quote from: gayboy on November 13, 2014, 11:10:57 AM
Camchain? Camchain Tensioner?

i have 04 R6 and tensioner gone on mine!
no its definately not the camchain i had problems with that on another r6 i had so i know its not that

ben68

Quote from: big gav on November 13, 2014, 11:47:54 AM
Its common for output shaft bearings to whine.

Get it hooned.
is it anything to worry about this has only started in the last week or so the problem is it's only about 3 miles to work from where i live though i do let the bike warm up a bit before i set off