Flush Fitting Indicators...Hellllllp.

Carbon_ZX6R · April 28, 2015, 08:24:20 AM

Quote from: Tiiimmmaaayyyy on April 28, 2015, 08:19:24 AM
Quote from: Carbon_ZX6R on April 28, 2015, 07:24:58 AM
your welcome , let us know if you run into trouble

Yes, any mechanical trouble be sure to ask Carbon for his advice........

im a font of knowledge thank you very much!! most of it may be useless but there is some good stuff in there!

Green_Ninja · April 28, 2015, 09:29:05 AM

Quote from: Carbon_ZX6R on April 28, 2015, 08:24:20 AM
Quote from: Tiiimmmaaayyyy on April 28, 2015, 08:19:24 AM
Quote from: Carbon_ZX6R on April 28, 2015, 07:24:58 AM
your welcome , let us know if you run into trouble

Yes, any mechanical trouble be sure to ask Carbon for his advice........
im a font of knowledge thank you very much!! most of it may be useless but there is some good stuff in there!

really

can you prove that

Carbon_ZX6R · April 28, 2015, 09:39:36 AM

Quote from: Green_Ninja on April 28, 2015, 09:29:05 AM
Quote from: Carbon_ZX6R on April 28, 2015, 08:24:20 AM
Quote from: Tiiimmmaaayyyy on April 28, 2015, 08:19:24 AM
Quote from: Carbon_ZX6R on April 28, 2015, 07:24:58 AM
your welcome , let us know if you run into trouble

Yes, any mechanical trouble be sure to ask Carbon for his advice........
im a font of knowledge thank you very much!! most of it may be useless but there is some good stuff in there!

really can you prove that

copthis1 · May 18, 2015, 07:34:34 PM

Quote from: Green_Ninja on April 27, 2015, 10:38:29 PM
in original form they have a retaining plate on the inside which can get stuck, however the indicators stay in fine without then so fitting the indicators is just a case of feeding the wires through the hole and then pushing the rubber supporting arm into the holes so that it fits flush against the lip on it, I find a small flat blade screwdriver helps here. My ZX6RG never had the retaining plates and neither does my ZX9R on which the indicators are incidental.

Super advice....merci.

Carbon_ZX6R · May 18, 2015, 08:07:33 PM

Quote from: copthis1 on May 18, 2015, 07:34:34 PM
Quote from: Green_Ninja on April 27, 2015, 10:38:29 PM
in original form they have a retaining plate on the inside which can get stuck, however the indicators stay in fine without then so fitting the indicators is just a case of feeding the wires through the hole and then pushing the rubber supporting arm into the holes so that it fits flush against the lip on it, I find a small flat blade screwdriver helps here. My ZX6RG never had the retaining plates and neither does my ZX9R on which the indicators are incidental.

Super advice....merci.

you got them yet?